Extended Reach Tool Holder- High Strength Solid Tool Steel

Use the Extended Reach Tool Holder to Extend Cutting Tool Reach into Deep Cavities or Pockets, 6.0″ Long, Holds 1/8″ Diameter Tool Bits

Use the Extended Reach Tool Holder for operations where an extra long tool is needed to reach into deep cavities or pockets, and where larger diameter Collet holding devices cannot get close enough to the cavity or pocket walls.

This straight shank tool extension is typically used with End Mills when additional reach length is needed when cutting and machining.

• Produced from high strength solid tool steel for maximum rigidity.
• Holds 1/8” (0.125”) (3.175mm)  diameter tools.
• 6 inches overall length.
• Extremely small 3/8” (0.375”) (9.52mm) overall diameter.
• Quick tool changes – change the cutting tool from the front without removing the tool holder from the spindle.
• Straight shank (0.375” diameter) (9.52mm) allows you to control how far the Tool Holder protrudes from your Collet.
• For use with CNC Mills, Lathes, and Grinders.
• This tool is designed for light finishing cuts only.

Operating Notes: Protrude the Extended Reach Tool Holder from your Collet the minimum amount necessary to reach into the pocket or cavity. The shaft may bend or whip if protruded too far from the Collet or too much sideways cutting pressure is applied. The Extended Reach Tool Holder is produced from high strength tool steel so it can be trammed in straight (straightened) in your spindle if necessary.