Extended Reach Toolholder

Straight Shank Extension Holds 0.125” (1/8”) Diameter Tools

Sale!

Extended Reach Toolholder

Use this Extended Tool Holder for operations where an extra long tool is needed to reach into deep cavities or pockets and where larger diameter collet holding devices will not allow getting close enough to the cavity or pocket walls.

  • Holds 1/8” (0.125”) diameter tools.
  • 6 inches overall length.
  • Extremely small 3/8” (0.375”) overall diameter.
  • Change the cutting tools from the front without removing the toolholder from the spindle.
  • Straight shank (0.375” diameter) allows you to control how far the toolholder protrudes from your collet.This tool is designed for light finishing cuts only.

Operating Notes: Protrude the Extended Tool Holder from your collet the minimum amount necessary to reach into the pocket or cavity. The shaft may bend or whip if protruded too far from the collet or too much sideways cutting pressure is applied. The Extended Tool Holder is produced from high strength tool steel so it can be trammed in straight (straightened) in your spindle if necessary.

Extended Reach Tool Holder

Extended Reach Toolholder

Part No: 10782 Category:

$91.05