Extended Tool Holder - Straight Shank Tool Extension.
Only 0.375” (3/8”) Overall Diameter - 6” Length
For Holding 0.125” (1/8”) Diameter Tools
- Use this Extended Tool Holder for operations where an extra long tool is needed to reach into deep cavities or pockets and where larger diameter collet holding devices will not allow getting close enough to the cavity or pocket walls.
- 6 inches overall length.
- Holds 1/8” (0.125”) diameter tools.
- Extremely small 3/8” (0.375”) overall diameter.
- Change the cutting tools from the front without removing the tool holder from the spindle.
- Straight shank (0.375” diameter) allows you to control how far the tool holder protrudes from your collet.
- This tool is designed for light finishing cuts only.
Operating Notes: Protrude the Extended Tool Holder from your collet the minimum amount necessary to reach into the pocket or cavity. The shaft may bend or whip if protruded too far from the collet or too much sideways cutting pressure is applied. Due to the extremely small shank diameter and length of the tool, the run out of the tool can be as much as 0.004” when the tool is protruded the full length of the shaft. The Extended Tool Holder is produced from high strength tool steel so it can be trammed in straight (straightened) in your spindle if necessary.
Extended Tool Holder |
|
|---|---|
Extended Tool Holder - Straight Shank Extension- Holds 1/8" Diameter Tool Bits |
|