When Precise Depth of Engraving Is Required
For use with the Standard Spring Loaded Engraving Tool - 3/4" diameter
- Control depth of engraving in increments of 0.001".
- System controls the exposure of the cutting tool to the engraved part.
- Tip gradations of 0.001” can be achieved and easily modified.
- Both an aluminum and plastic nosepiece are provided for engraving on softer materials such as plastic, brass or copper.
- The Plastic Nosepiece is suggested for very soft plastic where scratching may be possible.
- The Depth Control Engraving System includes Measured Collet Nut, Plastic Nosepiece, Aluminum Nosepiece, Set Screws (2) and Hex Wrench.
- In stock - ready to ship. Page down and order below.
|
Depth Control Engraving System for the Standard Spring Loaded Engraving Tool: Catalog No.: 10192 |
|
|---|---|
 |
System includes: 1-Measured Collet Nut, 1-Plastic Nosepiece, 1-Aluminum Nosepiece, 2-Set Screws and 1-Hex Wrench.
|
 |
|
|
|
|
* The Depth Control Engraving System and Spring Loaded Engraving Tool is covered by U.S. Patents 6,834,434, 7,093,368 and a pending utility patent application.
| Depth Control Engraving System - For Use with the Standard Spring Loaded Engraving Toolholder | Price / Order |
|---|---|
|
Depth Control Engraving System for the Standard Spring Loaded Engraving Tool.
System includes: 1-Measured Collet Nut, 1-Plastic Nosepiece, 1-Aluminum Nosepiece, 2-Set Screws and 1-Hex Wrench. Catalog No.: 10192 - $122.00 each |
|
| The Standard Spring Loaded Engraving Tool Kit needs to be purchased separately. To purchase the Standard Spring Loaded Engraving Tool Click Here. |
